HOW TO WEAR

          ※ Wash your hands so that you don't transfer dirt and germs to your eye before Wearing, Removing and Cleaning the lens. Try to avoid moisturizing soaps, as they are not good for contact lenses. Then, dry your hands with a lint-free towel.

• Wearing

1. Rinse the lens case clean with flow water and fill with lens solution. The lens solution must be for storage purpose. Do not use the lens solution for cleaning purpose.

2. Take the lens off from the container and completely immerse it in the lens solution of the lens case. Soak it for at least 10 minutes.

3. Lift the lens using a silicon-treated lens tweezers to avoid damaging the lens.

4. Check that lens is flipped or not. There's no obvious difference as shown in the picture below, so flip it over several times and check it out. If lens is flipped out, colors may look different or may cause discomfort.

5. Put the lens on the index finger of the right hand, lower a lower eyelid with the tip of a middle finger and raise an upper eyelid with that of another middle finger to widen an eye.

6. Approach the lens slowly toward the cornea and attach it lightly, looking in a mirror (Mind not to close an eye).

7. If the lens is attached to the cornea correctly, take the finger for widening the eyelid off slowly.

• Removing

1. Discard the lens solution in the lens case and the lens case clean with flow water.

2. Add a new solution into the lens case. Do not top-off the old solution.

3. Identify the location of a lens, looking in a mirror carefully.

4. Raise an upper eyelid with the finger of the left hand, lower a lower eyelid with the middle finger of the right hand and pick the lower part of the lens with the thumb and the index finger of the right hand to pull it out. Be careful not to let your fingernails touch the lens.

5. Soak the lens completely in the solution and close the lid.

          ※ The lens case must be replaced EVERY THREE MONTHS. The lens solution in the lens case must be replaced AT LEAST ONCE A DAY and if possible, do not store lenses in the same solution for more three days.

• Cleaning

1. Wash your hands so that you don't transfer dirt and germs to your eye. Try to avoid moisturizing soaps, as they are not good for contact lenses. Then, dry your hands with a lint-free towel.

2. Clean the lens with the recommended solution. Cleaning removes eye-produced buildup, cosmetics and other debris that impairs lens comfort. The FDA recommends that you rub the lens in the palm of your hand with a few drops of solution, even if you are using a "no-rub" product.

3. Rinse the lens again to remove the loosened debris, making sure to take as long as the package directs: Rinsing is an important step.

4. Place the lens in your clean lens case or lens holder and fill it with fresh solution; don't "top off" your old solution.

5. Repeat steps two through four for your other lens.